In order to deliver these sheets, we need to cut them down. This due to their size and weight, therefore is for ease of handling purposes.
Please call for information before placing order.

Grain runs across the length

This is a commercial board, all sides need trimming, usable size 1480 x 3000mm

A typical plywood panel has face veneers of a higher grade than the core veneers. The principal function of the core layers is to increase the separation between the outer layers where the bending stresses are highest, thus increasing the panel’s resistance to bending. As a result, thicker panels can span greater distances under the same loads. In bending, the maximum stress occurs in the outermost layers, one in tension, the other in compression. Bending stress decreases from the maximum at the face layers to nearly zero at the central layer. Shear stress, by contrast, is higher in the center of the panel, and zero at the outer fibers.

Applications
Floors, Walls and Roofs in house Constructions
Wind Bracing Panels
Vehicle Internal Body Work
Packages and Boxes
Scaffolding Materials

We offer a full cutting and edging service on all of our sheet material. 

Related Articles

About author View all posts Author website

admin

Leave a Reply

Your email address will not be published. Required fields are marked *